1.302022
USB Wi-fiモジュール PCBボード
USB Wi-fiモジュール PCBボード
Supply Voltage | 3-5V | |||
Consumption | 1.5W | |||
Working Mode | AP | |||
Transmission Speed | 54MHZ | |||
Antenna Pattern | External Antenna | |||
Video Format | MJPEG | |||
Resolution | Users can modify it through mobile phone software.
The default value is 640 * 480 |
|||
Camera Pixel | 0.3MP, 1MP, 2MP, 3MP, 5MP | |||
Baudrate | Support customization and modification | |||
External Interface | USB and serial port | |||
SSID Name | Accept the modification. The default password is 12345678 | |||
Transmitting Power | About 13.5DBM | |||
Sensitivity@PER | <-65dbm | |||
RF Power | -2482 | |||
PC operating system | Android 2.2 or above, apple mobile phone, PC | |||
Working Temperature | -10°C ~ +70°C |
Module Index | Index Requirements | Test
Resu |
Remark | |
Transmitting power |
frequency range(MHz) | Maximum output power(Mw) | Converted to dBm | |
2412-2482 |
1000mW (USA) |
Average power: 40mw-
50 |
802.11g/n: 12.50-
14.5dBm 802.11b:15-17dbm |
|
2412-2482 | 100mW
(Europe) |
As above | 20dBm | |
2412-2482 | 10mW(Japan) | As above | 10dBm | |
Transmit spectrum template |
Off center frequency | Deviation from the
highest power point |
Use 100KHz resolution bandwidth and 10KHz video bandwidth | |
11-22MHz | Above 30dBr | |||
Above 22mhz | Above 50dBr | |||
Transmit spectrum template | Within±25ppmzzz |
Within 0KHz |
10ppm |
|
Clock frequency error | Within±25ppm | Within 0KHz |
10ppm |
|
Risinge edge/ Falling edge/ Time | <2us | |||
EVM vector error |
Data rate
(Mbits/s) |
Less than (dB) |
There are many factors affecting this index, such as IQ gain mismatch, phase noise and so on. |
|
1 | -10 | <-18dbm | ||
2 | -10 | <-18dbm | ||
5.5 | -10 | <-18dbm | ||
11 | -10 | <-18dbm | ||
Receiving sensitivity |
Data rate
(Mbits/s) |
Sensitivity (dBm) | When the packet receiving rate is above 92%, the minimum transmit power is sensitivity. | |
1 | -76 | <-65dbm | ||
2 | -76 | <-65dbm | ||
5.5 | 76 | <-65dbm | ||
11 | -76 |
コメント
この記事へのトラックバックはありません。
この記事へのコメントはありません。